• 1/6 hp
• 2A 115V
• 25' Cord
• 3/4" NPT and 3/4" Garden Hose Adapter included

Features

• Thermoplastic body resists  impact, stress, and corrosion
• Self-cleaning trash-type impeller
• 1/6 hp air cooled PSC motor
• Shaft seal and lip seal
• Thermal overload protection
• Pumps down to 1/8"
• Completely submersible
• Removable bottom screen for easy cleaning 

Applications

• Pumping pool covers
• Irrigation
• Pumping flooded areas

Dimensional Data

• Data Weight: 7.5 lbs
• Height: 9.5" Major
• Width: 7"

• 1/2 hp
• 8A 115V
• Thermally protected motor
• Maximum Fluid Temperature:135°F 
• 20' Cord
• 3/4" Brass Garden Hose Connectors

Features

• One-piece cast aluminum pump and motor housing with integral carry handle
• Durable epoxy powder coat finish
• 20' Power cord
• Convenient ON/OFF switch
• 3/4" Brass garden hose connectors
• Glass reinforced thermoplastic impeller
• Permanently lubricated ball bearings
• Large prime plug with internal funnel design for easy priming
• Maximum discharge head of 105'
• Maximum suction lift of 15'
• Easily replaceable motor brushes

Applications

• General Water Transfer
• Draining Water Heaters
• Boosting Water Pressure by up to 45 psi
• Charging Hydronic Floor Systems with Glycol

Dimensional Data

• Data Weight: 10.5 lbs
• Height: 7" Major
• Width: 4 1/2"
• Length: 9 3/4"

NOTE: The Model 331 is not intended for use in wet or damp areas. Motor is not submersible. Not intended to pump chemicals or flammable liquids. 

• 1/3 hp
• 5.2A 115V
• Oil-filled
• Thermally protected
• 10' Cord
• Total Basin Capacity: 4.3 gallons

Features

• Compact design for tight areas
• Factory pre-assembled
• Fully automatic operation
• QuickTree® technology allows quick inspection and removal of float switch without disconnecting the plumbing
• Integrally molded rubber gaskets for a superior gas-tight seal
• Oil-filled, hermetically sealed motor with thermal-overload protection; 10', 3-wire power cord with grounded plug
• Corrosion-resistant polyolefin basin with molded-in connections
• Maintenance free, permanently lubricated sealed bearings
• 3/8" Solids handling
• Standard alarm and Wi-Fi alarmed  models available

Applications

• Bar sinks
• Laundry trays
• Dehumidifiers
• Utility sinks
• Gray wastewater drainage below gravity lines

Dimensional Data

• Data Weight: 13 lbs
• Height: 11 1/8"
• Major Width: 13 3/4"

Maximum fluid temperature 104°F continuous duty, 140°F intermittent duty. Not intended for use with chemicals.

• 1/2 hp
• 7.3A 115V
• 10' Cord
• Total Basin Capacity: 5.5 gallons

Features

• Factory pre-assembled
• Fully automatic operation
• QuickTree® technology allows quick inspection and removal of float switch without disconnecting the plumbing
• Oil-filled motor with thermal-overload protection
• Corrosion-resistant polyolefin basin with integrally molded rubber gasket for a superior gas-tight seal
• Maintenance-free, permanently lubricated sealed bearings
• 10' Power cord with ground plug
• 3/8" Solids handling
• 1/2 hp
• Standard alarm and Wi-Fi alarmed  models available

Maximum Fluid Temperature

• 180°F
• Not intended for use with chemicals.

Applications

• Laundry Trays
• Commercial Sinks
• Bar Sinks
• Dishwashers
• Dehumidifiers
• Wherever gray wastewater drainage is needed below gravity lines

Specifically designed for higher head applications such as commercial and industrial buildings.

Dimensional Data

• Data Weight: 16 lbs
• Major Height: 14 1/8"
• Major Width: 13 3/4"
• Inlet Height (from bottom of basin): 12-5/8"
• Total Capacity: 5.5 gallons
• Inlet Size: 2"
• Discharge Size: 2"
• Vent Size: 2"

• 1/6 hp
• 1.7A 115V
• 9' Cord
• Air-cooled
• Thermally Protected

Features

• Compact design for tight areas and in cabinets
• Factory pre-assembled
• Fully automatic operation
• Wet-end serviceability with easy to remove motor cartridge
• Integral check valve at bottom inlet connections
• Rubber gaskets for a superior gas-tight seal
• Float switch can be accessed and serviced without disconnecting piping
• Air-cooled motor with thermal-overload protection
• 9', 3-wire power cord with grounded plug
• Corrosion-resistant ABS basin with molded-in connections
• Maintenance free, permanently lubricated sealed bearings
• 1/8" Solids handling

Maximum Fluid Temperature

• 104°F (40°C) continuous duty
• 140°F (60°C) intermittent duty (10 seconds on/5 seconds off)

Applications

• Bar sinks
• Laundry trays
• Dehumidifiers
• Utility sinks
• Gray wastewater drainage below gravity lines
• Showers

Dimensional Data

• Data Weight: 13.5 lbs
• Major Height: 14.1"
• Major Width: 13.2"